Electrolumienscent Custom pattern sheet

Our Custom Pattern Sheet panels are designed to be shaped into smaller pieces.
You can cut the panel into any shape as long as you leave 2 terminals attached.
As you can see, there are two kinds of terminals along the edges of the sheet.
One terminal is connected to the back of the sheet(black coating) and another is connected to the front of the sheet.
You only have to connect the two terminals to an inverter to illuminate the sheet.
After you cut the panel, make sure you clean the edges because the black conductive material might touch the front panel causing a short circuit. Please handle the panel carefully to avoid electrical shocks.


A Custom Pattern Sheet panel is designed to be cut into smaller pieces and if you want to illuminate large panel(usually larger than A5), you need to reinforce the terminal electrically.
Use regular copper wires to reinforce the terminal.
Just spread the fine copper wire on the black back side panel as shown below.
You can always use this copper wire method even if the panel is smaller.
The copper wire doesn't even have to touch the terminal and you only need to reinforce the back side of the panel.


Click here to close this window.